Delivering to all 50 states Mon–Sat · 7am–7pm ET
Need help placing yours? ☎ (845) 343-0700
GiantLockBox Cart 0
Modifications · workshops

Converting a shipping container into a workshop.

Container workshops are the practical conversion most makers, mechanics, and woodworkers actually need. Not a container home (lots of code). Not just storage (no power, no light). A real working space, built for under $10K including electrical + lighting + insulation.

TL;DR
Cost + scope

Total cost: $5,000-$12,000 for a 20ft container converted to a working shop (container + insulation + electrical + lighting + workbench). 40ft adds $2,000-$4,000. No building permit usually required (it's "personal property" storage with electrical, not a dwelling). Build time: 2-4 weekends with a helper.

What's involved

The actual work, step by step.

  1. 01

    1. Pick the size

    20ft High-Cube is the sweet spot — 9'6" interior gives standing room with pegboard above. 40ft if you have heavy machinery (welder, lathe, drill press).

  2. 02

    2. Vent + insulate

    Two louvered vents (high + low for cross-flow) + closed-cell foam on walls + ceiling. Skip insulation in mild climates if you only use it spring/fall.

  3. 03

    3. Electrical (the key)

    60-100 amp subpanel. Plenty of outlets at bench height. Overhead LED panels (1 per 10 feet). 240V circuit if you'll run a welder or compressor.

  4. 04

    4. Workbench + storage

    Built-in bench along one wall (12-18 ft of bench in a 20ft container). Pegboard on the opposite wall. Heavy-duty shelves above the bench.

  5. 05

    5. Lighting

    Daylight LED panels (5000K). Add a few warm spots if you do detail work. Skylight is optional but transforms the space if you're cutting a roof.

  6. 06

    6. Climate (optional)

    Mini-split for year-round use ($1,500-$3,000 installed). Window AC for summer only ($300). Heater (electric or propane, with proper venting).

Start with the right shell

The container is half the build.

We sell containers, we don't build conversions — but the right starting container makes every step downstream easier. Here's what to pick.

  • → 20ft High-Cube — the workshop sweet spot (1,313 cu ft, 9'6" interior)
  • → 40ft High-Cube for serious machinery (welder, lathe, drill press)
  • → Cargo-Worthy condition — interior gets covered in framing anyway, no need for One-Trip
  • → One-Trip if exterior matters (visible from the house, neighborhood)
Browse containers →
Avoid these

Common mistakes that ruin the project.

Spec the right starting container

Spec a workshop container

Tell us your project — size, finish level, climate. We'll match the container shell that makes your conversion easier. We don't build the conversion; we make sure you start with the right shell.

Call (845) 343-0700
Call a Placement Expert

(845) 343-0700

Mon–Sat · 7am–7pm ET · Real humans, no call center

71 Dolson Ave · Middletown, NY 10940
☎ Call a placement expert (845) 343-0700